Licensing Requirements for Port Security.Port Security and Port-Channel Interfaces.Separate nonconsecutive port-channels with a comma and no spaces. Port-channel port-channel-list-Specifies a list of port channels. Separate nonconsecutive Ethernet ports with a comma and no spaces. Remove-Forbids removing ports from the group.Įthernet interface-list-Specifies a list of Ethernet ports. Mac-multicast-address | ipv4-multicast-address-Specifies the group Multicast address. No bridge multicast forbidden address mac-multicast-address Parameters To return to the default configuration, use the no form of this command.īridge multicast mode To configure the Multicast bridging mode, use the bridge multicast mode Interface (VLAN) Configuration mode command. switchxxxxxx(config)# bridge multicast filtering bridge multicast mode The following example enables bridge Multicast filtering. When this feature is enabled, unregistered Multicast traffic (as opposed to registered) will still be flooded.Īll registered Multicast addresses will be forwarded to the Multicast groups. Global Configuration mode User Guidelines All Multicast addresses are flooded to all ports. This command has no arguments or keywords. To disable Multicast address filtering, use the no form of this command. To enable the filtering of Multicast addresses, use the bridge multicast filtering Global Configuration mode command. This chapter contains the following sections: show bridge multicast reserved-addresses.show bridge multicast address-table static.bridge multicast ipv6 forbidden source group.bridge multicast ipv6 forbidden ip-address.bridge multicast forbidden source group.IP Routing Protocol-Independent Commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |